Cisco 3110 Message Manual page 51

Chapter 2 Message and Recovery Procedures
Error Message GBIC_SECURITY-4-GBIC_INTERR: Internal error occurred in setup for GBIC
interface [chars].
Note
Explanation
the specified SFP module interface. [chars] is the interface in which the SFP module is installed.
Recommended Action
problem persists, find out more about the error by using the show tech-support privileged EXEC
command and by copying the error message exactly as it appears on the console or system log and
entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For
more information about these online tools and about contacting IBM, see the
Reports" section on page
Error Message GBIC_SECURITY-6-SFP_INSERTED: Transceiver SFP [chars] module inserted
in [chars]
Note
Explanation
module for the interface specified in the message. The first [chars] is the module and the second
[chars] is the interface.
Recommended Action
Error Message GBIC_SECURITY-6-SFP_REMOVED: Transceiver SFP [chars] module removed
from [chars]
Note
Explanation
module from the interface specified in the message. The first [chars] is the module and the second
[chars] is the interface.
Recommended Action
OL-12191-01
This message applies only to the Catalyst Switch Module 3110X.
The system could not allocate resources or had some other problem during the setup for
Reload the switch by using the reload privileged EXEC command. If the
1-6.
This message applies only to the Catalyst Switch Module 3110X.
The online insertion and removal (OIR) facility detected a newly inserted transceiver
No action is required.
This message applies only to the Catalyst Switch Module 3110X.
The online insertion and removal (OIR) facility detected the removal of a transceiver
No action is required.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
GBIC_SECURITY Messages
"Error Message Traceback
2-35