Cisco 3110 Message Manual page 68

Catalyst switch module for ibm bladecenter system
Hide thumbs Also See for 3110:
Table of Contents

Advertisement

PLATFORM _IPC Messages
Error Message PLATFORM_IPC-3-MAX_LENGTH_EXCEEDED: [chars].
Note
Explanation
the maximum length. [chars] describes the error message.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
Error Message PLATFORM_IPC-3-MEMBER: [chars].
Note
Explanation
message.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
Error Message PLATFORM_IPC-3-STACK_EVENT: [chars].
Note
Explanation
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-52
This message applies only to the Catalyst Switch Module 3110.
An internal IPC application error occurred when an IPC message was sent that exceeded
Copy the message exactly as it appears on the console or in the system log.
This message applies only to the Catalyst Switch Module 3110.
There has been an IPC failure on a stack member switch. [chars] describes the error
Copy the message exactly as it appears on the console or in the system log.
This message applies only to the Catalyst Switch Module 3110.
There has been an IPC failure in the stack. [chars] describes the error message.
Copy the message exactly as it appears on the console or in the system log.
Chapter 2
"Error Message Traceback Reports" section on page
"Error Message Traceback Reports" section on page
"Error Message Traceback Reports" section on page
Message and Recovery Procedures
1-6.
1-6.
1-6.
OL-12191-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

3112

Table of Contents