Cisco 3110 Message Manual page 102

SPANTREE Messages
Error Message SPANTREE-4-PORT_NOT_FORWARDING: [chars] [chars] [chars] [chars].
Explanation
[chars] is the mode (for example, assert or clear), and the second [chars] is the severity (for example,
minor). The third [chars] is the interface name, and the fourth [chars] is the alarm string (for
example, port not forwarding).
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
Error Message SPANTREE-5-EXTENDED_SYSID: Extended SysId [chars] for type [chars].
Explanation
spanning tree. If enabled, the spanning-tree instance identifier is stored in the lower portion of the
bridge ID priority field and limits the allowed values for the bridge priority from 0 to 61440, in
increments of 4096. If disabled, the bridge ID priority field consists only of the configured priority,
but some spanning-tree features might not be available on a given platform (for example, support
for 4096 VLANs). On some platforms, this feature might be mandatory. The first [chars] is the
extended system ID state (enable or disable), and the second [chars] is the spanning-tree instance.
Recommended Action
Error Message SPANTREE-5-ROOTCHANGE: Root Changed for [chars] [dec]: New Root Port
is [chars]. New Root Mac Address is [enet].
Explanation
interface ID for the previous root port, the second [chars] is the interface ID for the new root port,
and [enet] is the Ethernet address of the new root port.
Recommended Action
Error Message SPANTREE-5-TOPOTRAP: Topology Change Trap for [chars] [dec].
Explanation
Recommended Action
Error Message SPANTREE-6-PORTADD_ALL_VLANS: [chars] added to all Vlans
Explanation
Recommended Action
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-86
This message appears when a port-not-forwarding alarm is set or cleared. The first
Copy the message exactly as it appears on the console or in the system log.
The extended system ID feature is either enabled or disabled for the given type of
No action is required.
The root switch changed for a spanning-tree instance. The first [chars] and [dec] is the
No action is required.
A trap was generated because of a topology change in the network.
No action is required.
The interface has been added to all VLANs. [chars] is the added interface.
No action is required.
Chapter 2
"Error Message Traceback Reports" section on page
Message and Recovery Procedures
1-6.
OL-12191-01