Cisco 3110 Message Manual page 70

PLATFORM_PBR Messages
Error Message PLATFORM_PBR-3-UNSUPPORTED_RMAP: Route-map [chars] not supported for
Policy-Based Routing.
Explanation
supported on this platform. This is a hardware limitation. [chars] is the route-map.
Recommended Action
ip next-hop ip-address route-map configuration command to reconfigure the route map to use only
these supported actions.
Error Message PLATFORM_PBR-4-CPU_SUPPORTED_ACTION: Set action in sequence [dec] of
route-map [chars] supported by forwarding to CPU.
Explanation
is not supported in hardware, so the packets are forwarded to the CPU for processing. The route-map
actions that invoke this forwarding are set interface, set ip default next-hop, set default interface,
or set ip df. [dec] is the action number, and [chars] is the route-map.
Recommended Action
reconfigure the route map action to route the packet to the specified next hop.
Error Message PLATFORM_PBR-4-RETRY_INSTALL: Route-map [chars] installed in hardware
upon retry.
Explanation
more route-maps previously failed to load because of lack of resources. [chars] is the route-map.
Recommended Action
Error Message PLATFORM_PBR-4-SDM_MISMATCH: [chars] requires sdm template routing.
Explanation
Recommended Action
routing configuration command, and then reload the switch by using the reload privileged EXEC
command.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-54
The route-map attached to an interface for policy routing contains an action that is not
Use the route-map map-tag permit global configuration command and the set
The route-map attached to an interface for policy-based routing contains an action that
Use the set ip next-hop ip-address route-map configuration command to
The PBR manager was able to fit the complete configuration into the hardware. One or
No action is required.
The routing template is not enabled. [chars] is the text string PBR.
Modify the SDM template to enable the routing template. Use the sdm prefer
Chapter 2 Message and Recovery Procedures
OL-12191-01