Cisco 3110 Message Manual page 76

PLATFORM_UCAST Messages
Error Message PLATFORM_UCAST-3-HSRP: [chars].
Explanation
error. [chars] describes the error.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
Error Message PLATFORM_UCAST-3-INTERFACE: [chars].
Explanation
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
Error Message PLATFORM_UCAST-3-RPC: [chars].
Explanation
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
Error Message PLATFORM_UCAST-6-PREFIX: One or more, more specific prefixes could not
be programmed into TCAM and are being covered by a less specific prefix
Explanation
Memory (TCAM) and is covered by a less specific prefix. This could be a temporary condition. The
output of the show platform ip unicast failed route privileged EXEC command lists the failed
prefixes.
Recommended Action
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-60
The Hot Standby Router Protocol (HSRP) module for unicast routing encountered an
Copy the message exactly as it appears on the console or in the system log.
A unicast routing interface error occurred. [chars] describes the error.
Copy the message exactly as it appears on the console or in the system log.
The RPC module for unicast routing encountered an error. [chars] describes the error.
Copy the message exactly as it appears on the console or in the system log.
The more specific prefix could not be programmed into Ternary Content Addressable
No action required.
Chapter 2
"Error Message Traceback Reports" section on page
"Error Message Traceback Reports" section on page
"Error Message Traceback Reports" section on page
Message and Recovery Procedures
1-6.
1-6.
1-6.
OL-12191-01