Dot1X Messages - Cisco 3110 Message Manual

DOT1X Messages

Error Message DHCP_SNOOPING-6-INTERFACE_NOT_VALID: Interface not valid. [dec]
bindings ignored.
Error Message DHCP_SNOOPING-6-LEASE_EXPIRED: Lease Expired. [dec] bindings ignored.
Error Message DHCP_SNOOPING-6-PARSE_FAILURE: Parsing failed for [dec] bindings.
Error Message DHCP_SNOOPING-6-VLAN_NOT_SUPPORTED: Vlan not supported. [dec] bindings
ignored.
DOT1X Messages
This section contains the IEEE 802.1x messages.
Error Message DOT1X-4-MEM_UNAVAIL: Memory was not available to perform the
802.1X action.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-18
The specified number of bindings were ignored when the switch read the database file
Explanation
because the interface in binding database is not available, the interface is a routed port, or the
interface is a DHCP snooping-trusted Layer 2 interface. [dec] is the number of bindings that the
switch ignores.
No action is required.
Recommended Action
The specified number of bindings were ignored when the switch read the database file
Explanation
because the DHCP lease expired. [dec] is the number of bindings.
Recommended Action No action is required.
The specified number of bindings were ignored when the switch read the database file
Explanation
because the database read operation failed. [dec] is the number of bindings.
No action is required.
Recommended Action
The specified number of bindings were ignored when the switch read the database file
Explanation
because the VLAN is no longer configured on the switch. [dec] is the number of bindings that the
switch ignores.
No action required.
Recommended Action
Explanation The system memory is not sufficient to perform IEEE 802.1x authentication.
Reduce other system activity to reduce memory demands. If the switch does
Recommended Action
not have enough memory, upgrade to a larger memory configuration.
Chapter 2 Message and Recovery Procedures
OL-12191-01