Dhcp_Snooping Messages - Cisco 3110 Message Manual

Catalyst switch module for ibm bladecenter system
Hide thumbs Also See for 3110:
Table of Contents

Advertisement

Chapter 2
Message and Recovery Procedures
Error Message CLS_ACC-7-ACC_VLAN: Selected vlan [dec] for consoleless access
Error Message CLS_ACC-7-CONFIG: Save access intf config: if: [chars], port num:
[dec], vlan [dec], admin-down?:[dec]
Error Message CLS_ACC-7-CONFIG_SUCCESS: [chars]

DHCP_SNOOPING Messages

This section contains the DHCP snooping messages.
Error Message DHCP_SNOOPING-3-DHCP_SNOOPING_INTERNAL_ERROR: DHCP Snooping internal
error, [chars].
Error Message DHCP_SNOOPING-4-AGENT_OPERATION_FAILED: DHCP snooping binding
transfer failed. [chars].
OL-12191-01
The switch assigned a VLAN to the management interface for consoleless access. [dec]
Explanation
is the VLAN ID.
No action is required.
Recommended Action
The switch has saved the interface configuration. After the switch exits Express Setup
Explanation
mode and the management interface is configured, the saved configuration takes effect. [chars] is
the name of the mode. The first [dec] is the port number, the second [dec] is the VLAN ID, and the
third [dec] is the port status.
Recommended Action
No action is required.
The management interface has been configured, or its original configuration has been
Explanation
restored. [chars] is the name of the configuration file.
No action is required.
Recommended Action
A software sanity check failed in the DHCP snooping process. [chars] is the error.
Explanation
Recommended Action
Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
The DHCP snooping binding transfer process failed because of the specified reason for
Explanation
failure. [chars] is the reason for failure.
No action is required.
Recommended Action
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
"Error Message Traceback Reports" section on page
DHCP_SNOOPING Messages
1-6.
2-15

Advertisement

Table of Contents
loading

This manual is also suitable for:

3112

Table of Contents