Gbic_Security_Crypt Messages - Cisco 3110 Message Manual

GBIC_SECURITY_CRYPT Messages

GBIC_SECURITY_CRYPT Messages
This section contains the 10-Gigabit Ethernet module security messages. The switch recognizes the
module as a Cisco module but identifies another problem with it.
The Catalyst Switch Module 3110X supports 10-Gigabit Ethernet modules but do not support GBIC
Note
modules. Although the error message text refers to GBIC interfaces and modules, the messages from the
switch actually refer to the 10-Gigabit Ethernet module interfaces and modules.
Error Message GBIC_SECURITY_CRYPT-4-ID_MISMATCH: Identification check failed for
GBIC in port [chars]
Note
Error Message GBIC_SECURITY_CRYPT-4-UNRECOGNIZED_VENDOR: GBIC in port [chars]
manufactured by an unrecognized vendor
Note
Error Message GBIC_SECURITY_CRYPT-4-VN_DATA_CRC_ERROR: GBIC in port [chars] has bad
crc
Note
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-36
This message applies only to the Catalyst Switch Module 3110X.
Explanation The small form-factor pluggable (SFP) module was identified as a Cisco SFP module,
but the system could not verify its identity. [chars] is the port.
Ensure that the Cisco IOS software running on the switch supports the SFP
Recommended Action
module. You might need to upgrade your software. Otherwise, verify that the SFP module was
obtained from Cisco or from a supported vendor.
This message applies only to the Catalyst Switch Module 3110X.
The small form-factor pluggable (SFP) module was identified as a Cisco SFP module,
Explanation
but the switch could not match its manufacturer with one on the known list of Cisco SFP module
vendors. [chars] is the port.
Ensure that the Cisco IOS software running on the switch supports the SFP
Recommended Action
module. You might need to upgrade your software.
This message applies only to the Catalyst Switch Module 3110X.
The small form-factor pluggable (SFP) module was identified as a Cisco SFP module,
Explanation
but it does not have a valid cyclic redundancy check (CRC) in the EEPROM data. [chars] is the port.
Ensure that the Cisco IOS software running on the switch supports the SFP
Recommended Action
module. You might need to upgrade your software. Even if the SFP module is unrecognized by the
switch, the SFP module might still operate properly but have limited functionality.
Chapter 2 Message and Recovery Procedures
OL-12191-01