Setting The Ip Address And Subnet Mask Of The Management Interface; Options; Setting The Ip Address And Subnet Mask Of The Management Interface: Example; Configuring The Management Interface Speed And Duplex Parameters - Cisco SCE8000 Configuration Manual

Chapter 5 Configuring the Management Interface and Security

Setting the IP Address and Subnet Mask of the Management Interface

The user must define the IP address of the management interface.

Options

The following options are available:
•
•
Changing the IP address of the management interface via telnet will result in loss of the telnet connection
and inability to reconnect with the interface.
From the SCE(config if)# prompt, type ip address ip-address subnet-mask and press Enter.
Step 1
The command might fail if there is a routing table entry that is not part of the new subnet defined by the
new IP address and subnet mask.
Changing the IP address of the management interface via telnet will result in loss of the telnet connection
Note
and inability to reconnect with the interface.
After changing the IP address, you must reload the SCE platform so that the change will take effect
Note
properly in all internal and external components of the SCE platform. (See
the SCE Platform, page

Setting the IP Address and Subnet Mask of the Management Interface: Example

The following example shows how to set the IP address of the SCE platform to 10.1.1.1 and the subnet
mask to 255.255.0.0.
SCE(config if)#ip address 10.1.1.1 255.255.0.0

Configuring the Management Interface Speed and Duplex Parameters

This section presents sample procedures that describe how to configure the speed and the duplex of the
Management Interface.
Both these parameters must be configured separately for each port.
•
•
•
OL-16479-01
IP address — The IP address of the management interface.
subnet mask — subnet mask of the management interface.
3-14.)
Interface State Relationship to Speed and Duplex, page 5-4
How to Configure the Speed of the Management Interface, page 5-4
How to Configure the Duplex Operation of the Management Interface, page 5-5
Configuring the Management Port Physical Parameters
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
Rebooting and Shutting Down
5-3