Configuring Name Servers; Options; How To Define Domain Name Servers; How To Remove A Domain Name Server - Cisco SCE8000 Configuration Manual
Service control engine
Hide thumbs
Also See for SCE8000:
- Installation and configuration manual (248 pages) ,
- Installation manual (51 pages) ,
- Removal and replacement procedures (36 pages)
Table of Contents
Advertisement
Chapter 5
Configuring the Management Interface and Security
Configuring Name Servers
•
•
•
•
Options
The following options are available:
•
How to Define Domain Name Servers
Use this command to specify the address of one or more name servers to use for name and address
resolution.
From the SCE(config)# prompt, type ip name-server server-address1 [server-address2
Step 1
[server-address3]] and press Enter.
Defines the servers at the specified addresses as domain name servers.
Defining Domain Name Servers: Example
The following example shows how to configure the two name server (DNS) IP addresses.
SCE(config)#ip name-server 10.1.1.60 10.1.1.61
How to Remove a Domain Name Server
From the SCE(config)# prompt, type no ip name-server server-address1 [server-address2
Step 1
[server-address3]] and press Enter.
Removes the specified server from the DNS list.
Removing a Domain Name Server: Example
The following example shows how to remove name server (DNS) IP addresses.
SCE(config)#no ip name-server 10.1.1.60 10.1.1.61
OL-16479-01
Options, page 5-45
How to Define Domain Name Servers, page 5-45
How to Remove a Domain Name Server, page 5-45
How to Remove All Domain Name Servers, page 5-46
server-ip-address — The IP address of the domain name server. You can define more than one DNS
server (server-ip-address1, server-ip-address2, server-ip-address3)
Domain Name Server (DNS) Settings
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
5-45
Advertisement
Table of Contents
