Configuring The Behavior Of The Sce Platform In Case Of Failure Of The Sm; Options; Configuring The Sm-Sce Platform Connection Timeout - Cisco SCE8000 Configuration Manual

Chapter 7 Configuring the Connection

Configuring the Behavior of the SCE Platform in Case of Failure of the SM

Options

The following options are available:
•
•
To specify the action that the SCE platform will perform if the SCE-SM connection fails, use this
command.
From the SCE(config if)# prompt, type subscriber sm-connection-failure action
Step 1
[force-failure|none|remove-mappings|shut] and press Enter.
To specify that the system operational-status of the SCE platform should be 'warning' if the SCE-SM
connection fails, use this command.
From the SCE(config if)# prompt, type subscriber sm-connection-failure warning and press Enter.
Step 1

Configuring the SM-SCE Platform Connection Timeout

You can also configure the timeout interval; the length of time that the SM-SCE platform connection is
disrupted before a failed connection is recognized and the configured behavior is applied.
Options
The following option is available:
•
From the SCE(config if)# prompt, type subscriber sm-connection-failure timeout interval and press
Step 1
Enter.
Configures the connection timeout.
OL-16479-01
action—The specified action will be performed in case of loss of connection between the SCE
platform and the SM.
Possible actions are:
force-failure — Force failure of SCE platform. The SCE platform then acts according to the
–
behavior configured for the failure state.
remove-mappings — Remove all current subscriber mappings.
–
shut — The SCE platform shuts down and quits providing service.
–
none (default) — Take no action.
–
warning—The system operational-status of the SCE platform should be 'warning' in case of loss of
connection between the SCE platform and the SM. No action is taken.
interval — the timeout interval in seconds
Configuring the SCE Platform/SM Connection
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
7-13