How To Exit From The Privileged Exec Mode And Revert To The Viewer Mode; How To Exit From The Global Configuration Mode; Navigating Between Configuration Modes; Entering And Exiting Global Configuration Mode - Cisco SCE8000 Configuration Manual

Chapter 2 Command Line Interface
•

How to exit from the Privileged Exec mode and revert to the Viewer mode

At the SCE# prompt, type disable, and press Enter.
Step 1
The SCE> prompt for the Viewer and User Exec mode appears.

How to exit from the Global Configuration Mode

At the SCE (config)# prompt, type exit, and press Enter.
Step 1
The appropriate prompt for the previous level appears.
Example:
This example illustrates how to change the authorization level from User to Root, and then revert back
to Admin. No password is required for moving to a lower authorization level.
SCE(config-if)#exit
SCE(config)#

Navigating Between Configuration Modes

•
•

Entering and Exiting Global Configuration Mode

•
•

How to enter the Global Configuration Mode

At the SCE# prompt, type configure and press Enter.
Step 1
The SCE(config)# prompt appears.
OL-16479-01
To exit from one mode to another with the Admin authorization level (these are the various
configuration modes), use the exit command.
Entering and Exiting Global Configuration Mode, page 2-13
Interface Configuration Modes, page 2-14
How to enter the Global Configuration Mode, page 2-13
How to exit the Global Configuration Mode, page 2-14
Navigating Between Configuration Modes
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
2-13