Configuring Subscriber Aging; How To Enable Aging For Anonymous Group Subscribers; How To Enable Aging For Introduced Subscribers; How To Disable Aging For Anonymous Group Subscribers - Cisco SCE8000 Configuration Manual

Chapter 9 Managing Subscribers

Configuring Subscriber Aging

•
•
•
•
•
•
•
•
As explained previously
when no traffic sessions assigned to it have been detected for a certain amount of time. Aging may be
enabled or disabled, and the aging timeout period (in minutes) can be specified.
Aging can be configured separately for introduced subscribers and for anonymous subscribers.
Use the following commands to configure and monitor aging.
•
•
•

How to Enable Aging for Anonymous Group Subscribers

From the SCE(config if)# prompt, type subscriber aging anonymous and press Enter.
Step 1

How to Enable Aging for Introduced Subscribers

From the SCE(config if)# prompt, type subscriber aging introduced and press Enter.
Step 1

How to Disable Aging for Anonymous Group Subscribers

From the SCE(config if)# prompt, type
Step 1
OL-16479-01
How to Enable Aging for Anonymous Group Subscribers, page 9-21
How to Enable Aging for Introduced Subscribers, page 9-21
How to Disable Aging for Anonymous Group Subscribers, page 9-21
How to Disable Aging for Introduced Subscribers, page 9-22
How to Set the Aging Timeout Period for Anonymous Group Subscribers, page 9-22
How to Set the Aging Timeout Period for Introduced Subscribers, page 9-22
How to Display Aging for Anonymous Group Subscribers, page 9-22
How to Display Aging for Introduced Subscribers, page 9-22
(Aging Subscribers, page
[no] subscriber aging
subscriber aging timeout
show interface linecard 0 subscriber aging
9-3, aging is the automatic removal of a subscriber
no subscriber aging anonymous
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
Configuring Subscriber Aging
and press Enter.
9-21