Configuring A Forced Failure; How To Force A Virtual Failure; How To Exit From A Virtual Failure; Configuring The Failure Recovery Mode - Cisco SCE8000 Configuration Manual

Chapter 7 Configuring the Connection
Note

Configuring a Forced Failure

Use the following commands to force a virtual failure condition, and to exit from the failure condition
when performing an application upgrade.
•
•

How to Force a Virtual Failure

From the SCE(config if)# prompt, type force failure-condition and press Enter.
Step 1
The system asks for confirmation
Forcing failure will cause a failover - do you want to continue? n
Step 2 Type ' Y' and press Enter to confirm the forced failure.

How to Exit from a Virtual Failure

From the SCE(config if)# prompt, type no force failure-condition and press Enter.
Step 1
Exits from the virtual failure condition.

Configuring the Failure Recovery Mode

The failure-recovery operation-mode command defines the behavior of the system after boot resulting
from failure.
OL-16479-01
The statistics are updated only if the system is configured to work in Enhanced Open Flow (i.e.
following settings are disabled:
Classical Open Flow mode, VAS, TCP no bypass est, etc.).
The statistics are updated once every two minutes
SCE>
How to Force a Virtual Failure, page 7-11
How to Exit from a Virtual Failure, page 7-11
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S

Configuring a Forced Failure

7-11