Configuring Mappings; Options; How To Add A Mapping To A Category; How To Remove A Mapping From A Category - Cisco SCE8000 Configuration Manual

Chapter 8 Raw Data Formatting: The RDR Formatter and NetFlow Exporting

Configuring Mappings

Use these command to add or remove a mapping.
•
•
•
•

Options

The following options are available:
•
•

How to Add a Mapping to a Category

From the SCE(config)# prompt, type rdr-formatter rdr-mapping (tag-id tag-number
Step 1
category-number category-number) and press Enter.
If the table already contains a mapping with the same tag and category number, an error is issued and
nothing is done.

How to Remove a Mapping from a Category

From the SCE(config)# prompt, type no rdr-formatter rdr-mapping (tag-id tag-number
Step 1
category-number category-number) and press Enter.

How to Restore the Default Mapping for a Specified RDR Tag

From the SCE(config)# prompt, type default rdr-formatter rdr-mapping tag-id tag-number and press
Step 1
Enter.
OL-16479-01
Options, page 8-15
How to Add a Mapping to a Category, page 8-15
How to Remove a Mapping from a Category, page 8-15
How to Restore the Default Mapping for a Specified RDR Tag, page 8-15
tag-umber — The complete 32 bit value given as an hexadecimal number. The RDR tag must be
already configured in the Formatter by the application.
category-number — Number of the category (1-4) to which to map the RDR tag.
Configuring Dynamic Mapping of RDRs to Categories
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
8-15