Table of Contents
Advertisement
Setting Up External Storage Device (Optional)
To store and access media from an external storage device, such as a network hard drive or USB memory
device, attach the USB drive to the Cisco Controller USB port and configure or scan the media from
Composer Pro.
See the
Configuring the Cisco Controller 200
After you install and connect the hardware (such as a touchscreen, TV, lights, etc.), use the Composer
Pro software to configure the devices and customize the system.
See the
Restoring the Device to the Factory Settings
Complete the following procedure to the Cisco Controller 200 system or the factory default image.
This action deletes the Composer Pro project.
Caution
Procedure
Step 1
On the bottom of the device, insert the end of a paper clip into the small hole.
Step 2
Power cycle the device while pressing and holding the Factory Restore button for about 5-7 seconds and
the Status (Wi-Fi) LED blinks orange. This action starts the recovery process.
Resetting the Device Network Settings
Complete the following procedure to reset the Cisco Controller 200 to the network defaults.
Procedure
Power cycle the Cisco Controller and press the Identification button on the front of the device until the
Step 1
Data, Link, and Power LEDs are solid blue; immediately release the button.
Step 2
If during the boot sequence, the Status LED stays Orange, press and hold the Identification button until
the LED blinks blue, and then release it.
Tip
OL-27357-01
Cisco Smart+Connected Residential Installation and Configuration Guide
Cisco Smart+Connected Residential Installation and Configuration Guide
If the Cisco Controller is connected to a TV, a message will appear indicating when to let go of
the button.
Setting Up External Storage Device (Optional)
Cisco Smart+Connected Controller 200 Reference Guide
for more information.
for more information.
9
Advertisement
Table of Contents
