Entering Management Interface Configuration Mode; How To Enter Linecard Interface Configuration Mode - Cisco SCE8000 Configuration Manual

Chapter 2 Command Line Interface

Entering Management Interface Configuration Mode

The management interfaces are Gigabit Ethernet interfaces. Before you can configure the parameters for
the management interface, you must be in the GigabitEthernet Interface Configuration Mode.
How to Enter Mng Interface Configuration Mode
To enter Global Configuration Mode, type configure and press Enter.
Step 1
The
To enter GigabitEthernet Configuration Mode, type interface GigabitEthernet 1/1 and press Enter.
Step 2
The
The system prompt changes to reflect the higher level mode.
How to Return to the Global Configuration mode
Type exit and press Enter.
Step 1

How to Enter Linecard Interface Configuration mode

The following procedure is for entering LineCard Interface Configuration mode. The procedures for
entering the other interfaces are the same except for the interface command as described above.
Step 1 To enter Global Configuration Mode, at the SCE# prompt, type configure and press Enter.
The
To enter LineCard Interface Configuration mode, type interface Linecard 0 and press Enter.
Step 2
The
To return to Global Configuration Mode, type exit and press Enter.
Step 3
The
To exit Global Configuration Mode, type exit and press Enter.
Step 4
OL-16479-01
prompt appears.
SCE(config)#
prompt appears.
SCE(config-if)#
prompt appears.
SCE(config)#
prompt appears.
SCE(config-if)#
prompt appears.
SCE(config)#
Navigating Between Configuration Modes
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
2-15