Configuring The Management Port; How To Enter Management Interface Configuration Mode; Configuring The Management Port Physical Parameters; C H A P T E R 5 Configuring The Management Interface And Security - Cisco SCE8000 Configuration Manual

Configuring the Management Port

Configuring the Management Port
Perform the following tasks to configure the management port:
•
•
Cable the management port, connecting it to the remote management console via the LAN.
Step 1
Configure the management port physical parameters. (See
Step 2
Parameters, page

How to Enter Management Interface Configuration Mode

interface Mng The GBE management interface is configured as follows:
•
•
Step 1 Type configure and press Enter.
Enters Global Configuration mode.
The command prompt changes to SCE(config)#.
Type interface GigabitEthernet 1/1 and press Enter.
Step 2
Enters GigabitEthernet Interface Configuration mode.
The command prompt changes to SCE(config-if)#

Configuring the Management Port Physical Parameters

This is a Gigabit Ethernet interface and is used for management operations and for transmitting RDRs,
which are the output of traffic analysis and management operations.
•
•
•
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
5-2
Configure the IP address and subnet mask
Configure physical parameters:
Speed
–
Duplex
–
5-2.)
mode: Gigabit Ethernet Interface configuration mode
interface designation: 1/1
Setting the IP Address and Subnet Mask of the Management Interface, page 5-3
Configuring the Management Interface Speed and Duplex Parameters, page 5-3
How to Monitor the Management Interface, page 5-5
Chapter 5 Configuring the Management Interface and Security
Configuring the Management Port Physical
OL-16479-01