Service Loss - Cisco SCE8000 Configuration Manual

Service Loss

CPU Utilization
•
•
It is advisable to consider sizing of the solution when the CPU utilization exceeds 75% regularly at peak
hours.
Flows Capacity
•
•
It is advisable to consider sizing of the solution when the flows capacity utilization exceeds 90%
regularly at peak hours.
Subscribers Capacity
•
•
The Cisco SCE8000 platform supports up to 250K subscribers. You should make sure that the number
of Introduced Subscribers plus the number of Anonymous Subscribers stays below this figure.
It is advisable that when subscribers utilization exceeds 90%, special attention should be given and
sizing should be reconsidered.
Service Loss
Service Loss is an event which occurs when the SCE platform does not provide the processing it was
expected to perform for any transaction in the network. This can occur due to either CPU or Flows
shortage.
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
B-2
SNMP
cpmCPUTotal1minRev and cpmCPUTotal5minRev, available for each Traffic Processor.
Refer to the Cisco process MIB for more information.
CLI commands
show snmp MIB cisco-process | include cpmCPUTotal1minRev
show snmp MIB cisco-process | include cpmCPUTotal5minRev
SNMP
cscTpFlowsCapacityUtilization available for each Traffic Processor.
Refer to the cisco-service-control-tp-stats MIB for more information.
CLI command
show snmp MIB cisco-service-control-tp-stats | include cscTpFlowsCapacityUtilization
SNMP
cServiceControlSubscribersInfoEntry
Refer to the cisco-service-control-subscriber MIB for more information
CLI command
show snmp MIB cisco-service-control-subscriber
Appendix B Monitoring SCE Platform Utilization
OL-16479-01