Cisco D9854 Installation And Configuration Manual page 366

Chapter 6 Service and Maintenance
Alarm Message
Type
FEC USB Flash Set
(D9854-I only)
FEC USB Flash Clear
(D9854-I only)
FEC FPGA Set
Status
(D9854-I only)
342
Message Cause/Remedy
FEC USB Flash not Cause: FEC USB
FLASH not
found
installed. This
may occur in
Production if the
USB module is not
inserted before the
first power on the
board.
Remedy: Ensure
that the FEC USB
connector and
FLASH module
are installed.
FEC USB Flash –
OK
Failed to find or Cause: Cannot
load FEC FPGA find the FEC
FPGA file in the
binary
USB FLASH, or it
failed to open,
read, or load the
file to the FEC
FPGA.
Remedy: Ensure
that the USB
FLASH is
installed,
formatted, and the
image is loaded.
Also, ensure that
the FEC FPGA is
installed and the
CPLD is properly
programmed.
Description Severity
FEC USB Major
FLASH mount
failed.
– Major
The FEC FPGA Major
image is not
found in the
USB FLASH, or
the file cannot
be loaded to
the FEC FPGA
for any reason.
This will occur
in production
until the USB
FLASH is
installed,
formatted, and
the image is
loaded.
ID
92300
92300
92400