Table of Contents
Advertisement
LED
ALARM
SIGNAL
Navigation/Selection Keypad
Throughout this manual, there are references to parts of a keypad on the front of the
receiver.
The navigation keys (LEFT, RIGHT, UP, and DOWN) and the SELECT key are the
primary controllers. Each navigation key performs various functions, depending on
the current state of the menu system (that is, sometimes the left navigation key
backspaces over an entry and sometimes moves the cursor to a different menu item).
Once the cursor is over the desired function, pressing the SELECT (center key) key
selects the current item. Pressing the SELECT key stores any entered values.
Signal
Explanation
State/Color
Red
Solid for five seconds indicates a Warning.
Red
Flashing indicates an Alarm.
Green
Solid indicates all of the following conditions:
active RF inputs are enabled, locked to a
signal, and are not muted.
all outputs are operating without an error.
Green
Flashing indicates one of the following
conditions:
difficulty with an input, route, or output.
one or more of the inputs are not
synchronized.
one or more ASI outputs are routed, but
muted by a fault condition.
no RF signal is present or detected, or it is
muted.
receiver is not authorized to receive the
program.
Off
Off indicates all of the following conditions:
no RF input signal is available, enabled or
detected, or the input is muted.
no ASI input is present.
no valid inputs are available.
About the Front Panel
45
Advertisement
Table of Contents
