Cisco D9854 Installation And Configuration Manual page 242

Hide thumbs Also See for D9854:

Table of Contents

Chapter 5 Web GUI Setup and Monitoring

From the Relay Mode drop-down list, choose the relay mode that can be

programmed to respond to an Alarm state, Warning statue, or the state of one of

the eight cue trigger pins. The response is generated at the Cue Tone/Relay

output on the rear panel of the receiver. The following table shows what the

possible field settings are and their relationship to the receiver output:

If the Relay Mode is set to Trigger, choose the cue trigger bit/pin that will

activate the relay from the Relay Trigger Bit drop-down list (1 to 8).

Click Apply.

Unit Power Off

Active (selected in PNC) Close

Relay Contact