Table of Contents
Advertisement
Chapter 4 Front Panel Operation
MOIP Streams
Menu Item
ID
User Rate (Mbps)
Intf Mode (D9854
only)
TS/IP
PCR@IP Start
(D9854 only)
MOIP
Min IP/s
TOS (Type Of
Service)
122
Description
Select the stream to configure.
This parameter controls the
output rate when Rate Control
is set to User.
Note: Output data will be
partially or completely lost if
the payload (bit rate) of the
transport to be encapsulated is
higher than the user-defined
output bit rate.
This selects the MPEG over IP
output port.
This selects the maximum
number of transport packets
per IP packet.
This selects whether to always
transmit a new IP packet when
a new Program Clock Reference
(PCR) arrives.
Selects the transport protocol to
be used for the output stream.
This selects the minimum
number of IP packets per
second.
This sets the quality of service.
Parameters
1 to 16
If SPTS Svc Chans Only, SPTS MAP
Svc Chans Only, or SPTS Full DPM
Control is selected as the Output
Mode, 1 to 16 indicates the SPTS
streams.
If No Output, Passthrough, Service
Chans Only, MAP Passthrough, Full
DPM Control, or MAP Svc Chans
Only is selected as the Output Mode,
1 indicates MPTS stream and 2 to 16
are not applicable.
0 to 206 Mbps
None - Disables the MPEG over IP
interface.
Data Port - Always output data on the
Data port.
Control Port - Always output data on
the Management port.
1 to 7
Yes or No
RTP or UDP
0, 2 to 1000 for D9854
0, 3 to 99999 for D9854-I
0 to 255
Advertisement
Table of Contents
