Table of Contents
Advertisement
Chapter 5 Web GUI Setup and Monitoring
To add a unicast route:
a
Click Add Row.
b Type the Destination IP Address that sets the destination for the unicast
route.
c
Set the number of CIDR (Classless Inter-Domain Routing) bits in the network
Mask (8 to 30).
d Set the Gateway Address on the Network, used to expose the receiver to a
WAN. The following table shows the most commonly used Subnet mask
values to enter for a chosen IP address mask, which will depend on the size
of your network.
Mask
8
16
24
e
Check the Port 1 or Port 2 check box. The management port is port 1 and the
data port is port 2.
5
Click Save. The routing information is displayed in the Installed Unicast Routes
table. If the configured routing information has an inactive port, then the routing
information is not displayed in the Installed Unicast Routes table.
270
Subnet Mask
255.0.0.0
255.255.0.0
255.255.255.0
Advertisement
Table of Contents
