Cisco D9854 Installation And Configuration Manual page 109

Menu Item Description
Revertive Delay Time to wait before reverting back to the
primary port once the primary port is active
again.
Note: If Non-Revertive is set as the Type, this
field does not apply.
If set to Yes, it will trigger the MPEG over IP
A/V Trigger
input redundancy failover if audio/video loss
is detected.
If set to Yes, it will trigger the MPEG over IP
PCR Trigger
input redundancy failover if program PCR loss
is detected.
If set to Yes, it will trigger the MPEG over IP
Prog Trigger
input redundancy failover if program PMT
loss is detected.
Idx The IP address entry number (index) for the
Source Filter list.
If White List is selected as the Src Filter, the
IP Address
unit will only receive streams from the trusted
IP addresses listed.
If Black List is selected as the Src Filter,
the unit will receive all streams except
from the IP addresses of hosts listed.
Press ADV to enter an address.
Tune Mode
Custom
This menu is where you set up your custom properties. Select the channel to set up
and then edit it.
Menu Item Description
Services List Mode If using custom tune mode,
select which tables are required
for tuning.
BAT This is not supported in the
current release.
Parameters
0 to 30 seconds
Yes or No
Yes or No
Yes or No
Valid host IP address
Parameters
Degraded or Rigorous.
Rigorous - Requires all service list tables
to be present to acquire the signal.
Degraded - Requires any service list
table to be present to acquire the signal.
No
Setup Menu
85