Table of Contents
Advertisement
Connector
ASI Input
ASI Output
TS Outputs
TS Inputs/Outputs
(D9854-I only)
Management
HD-SDI Outputs
RS-232 Data
Cue Tone/Cue Trigger
Relay Outputs
Composite Video
Outputs
Component Video
Outputs
AES-3id Audio Outputs
Balanced Audio Outputs
Ground
Power
Description
Asynchronous Serial Interface Input.
One Asynchronous Serial Interface Output.
This is for the MPEGoIP and MPE outputs.
The MPEGoIP output transmits the
decrypted transport stream encapsulated in
IP packets to a groomer for distribution. The
MPE output receives and outputs the IP
data packets from the incoming transport
stream.
The MPEGoIP input (D9854-I only) allows
the decoder to receive its streams from the
terrestrial IP network.
Supports the following network protocols:
Telnet, SSHv2, HTTP, HTTPS, SNMPv2,
Syslog/DTX, SNTP, FTP (client side), TFTP,
and MPEGoIP output (D9854 only).
M1 and M2 provide HD serial digital video
with embedded audio output for HD
applications according to SMPTE-292M.
RS-232 data output: 7 bits, even parity, 1
stop bit, up to 38.4 kb/s. These outputs are
user-configurable via the Setup menu on
the front panel.
Program relay provides programmed
responses for alarms, cue trigger states for
ad-insertion equipment, or a cue tone
output for connection to ad-insertion
equipment.
CVBS 1 and CVBS 2 provide two identical
SD composite video outputs for monitoring
applications.
SD to HD upconverted component video
output for HD monitoring applications.
AES-3id outputs. One output for each stereo
channel.
Audio 1 and Audio 2 provide two stereo
pairs or four mono channels.
Screw.
AC power.
D9854/D9854-I Receiver Rear Connector Panel
Type
BNC
BNC
RJ-45
RJ-45
BNC
9-pin sub-D female
15-pin sub-D female
BNC
BNC
BNC
Terminal Blocks
Grounding point for
the receiver
IEC 60320 Sheet 14
31
Advertisement
Table of Contents
