Cisco D9854 Installation And Configuration Manual page 197

Hide thumbs Also See for D9854:
Table of Contents

Advertisement

3
If Multicast is selected, enter the multicast destination IP address in the
Multicast Address field.
4
From the FEC Mode drop-down list, choose the type of expected FEC streams
for the decoder to analyze and use. Choose 1D if the FEC columns stream is
expected or 2D if FEC columns stream and rows stream are expected. Otherwise,
choose None to drop all the FEC streams.
5
In the TS Destination Port field, enter the destination port number (1 to 65534).
If you are expecting a transport stream with RTP encapsulation only, you must
enter an even port number. For UDP encapsulated input streams, you can enter
an even or odd port number.
Note: FEC is only supported for RTP transport streams.
6
If FEC Mode is set to 1D or 2D, enter the FEC destination UDP port number of
the column FEC stream (2 to 65534, even only) in the FEC Columns Port field.
We recommend that you set the columns port number to TS Destination Port +
2.
If the FEC Mode is set to 2D, in addition to entering the FEC columns port
number, enter the FEC destination UDP port number of the row FEC stream in
the FEC Rows Port field (2 to 65534, even only). We recommend that you set the
rows port number to TS Destination Port + 4.
7
From the Source Filter drop-down list, choose the source (host) filtering mode
(None, White List, or Black List).
Note: Source filtering also applies to IGMP (v3 only). For more information, see
Protocol Control Settings.
The incoming streams are always filtered based on user-configured destination
information (destination IP address and UDP ports). In addition, they can be
filtered based on selected Source Filter mode.
Choose None to receive streams without source restrictions.
Choose White List to only allow streams from the defined list of hosts/servers.
Choose Black List to allow streams from any host/server, except for the ones
defined in the list of hosts/servers.
The list of hosts/servers is defined in the Source Filter Setup window. To define
the hosts/servers:
Setting up Input Information
173

Advertisement

Table of Contents
loading

This manual is also suitable for:

D9854-i

Table of Contents