Table of Contents
Advertisement
Chapter 5 Web GUI Setup and Monitoring
1
From the user interface of the D9854/D9854-I, choose Input > Disaster
Recovery. The Disaster Recovery Setup page is displayed.
2
From the Enable Disaster Recovery drop-down list, choose to enable or
temporarily disable the disaster recovery feature. Choose Yes (default) to enable
disaster recovery. Choose No to set the disaster recovery into maintenance mode.
It will automatically set the Disaster Recovery back to Yes after five minutes.
This prevents the user from accidentally disabling disaster recovery
permanently. To disable disaster recovery, remove all the disaster recovery
configurations (Search Path settings below).
The maintenance mode allows you to perform any maintenance operations (such
as IP setup), without the unit declaring disaster and initiate a dis aster recovery
search path.
Note: Although the default is set to Yes, the disaster recovery is not operational
until the Search Path is configured.
3
From the Disaster Recovery Profile drop-down list, choose the disaster recovery
setting to use. Choose Local to use the disaster recovery settings configured on
the receiver, if the PNC uplink is configured to allow local disaster recovery.
Choose Uplink to use the PNC disaster recovery profile. The PNC disaster
recover profile is configured by the PNC uplink administrator. For more
information, contact your PNC uplink administrator.
Note: The PNC uplink determines whether the local disaster recovery is used,
regardless of the Disaster Recovery Profile setting. For more information, see
Disaster Recovery (on page 8).
184
Advertisement
Table of Contents
