Table of Contents
Advertisement
Chapter 4 Front Panel Operation
Menu Item
Description
Output Mode
Select the DPM output mode
for the current output.
With the exception of No
Output and Full DPM Control,
selecting a mode will configure
the DPM settings to achieve the
specified behavior. In this way,
they act as DPM presets.
The Config Type is changed
from Unmodified to Edited by
User.
We highly recommend that you
use either one of these basic
modes, or, for advanced setup,
enter the DPM mapping before
setting the Output Mode.
120
Parameters
No Output - No MPEGoIP output will be generated.
Passthrough - All PEs will be set to Pass and other DPM
settings will also be set.
Service Chans Only - This is similar to Passthrough, except
that only channels applied to program entries are available
on the output.
MAP Passthrough - The output will be identical to the
input, except that channels assigned to PEs and PIDs will
be mapped using the DPM settings. If the input is tuned to
a valid channel, the PEs are automatically set to Map.
Otherwise, the PEs are automatically set to Drop. When
selecting MAP Passthrough, the option to re-sync will be
provided. If you select Yes, it will set the DPM mapping to
the last valid (or saved) configuration. If you select No, it
will use the existing DPM maps. If the PE is mapped, it
uses the last saved output MAP configuration. The output
map (for example, output channel PMT) does not change
automatically if the input or channel number is changed.
MAP Svc Chans Only - This is similar to MAP
Passthrough, except that only channels applied to program
entries are available on the output. If the input is tuned to a
valid channel, the PEs are automatically set to Map.
Otherwise, the PEs are automatically set to Drop. When
selecting MAP Svc Chans Only, the option to re-sync will
be provided. If you select Yes, it will set the DPM mapping
to match the current input. If you select No, it will use the
existing DPM maps. If the PE is mapped, it uses the last
valid input. The output map (for example, output channel
PMT) does not change automatically if the input or channel
number is changed.
Full DPM Control - The output will be generated according
to the DPM setting.
SPTS MAP Svc Chans Only (D9854-I only) - The service
channel is mapped to the preconfigured channel number,
PMT, and ES PIDs.
SPTS Svc Chans Only (D9854-I only) - The service channel
is passed with the same channel number, PMT PID, and ES
PID numbers.
SPTS Full DPM Control (D9854-I only) - The output will be
generated according to the DPM settings on the MPEG
over IP Digital Program Mapping page. This is a manual
control setting.
Advertisement
Table of Contents
