Setting Up Cue Tone - Cisco D9858 Installation And Configuration Manual

Setting up Cue Tone

1 From the user interface of the D9858, choose Audio & Video > Cueing > Cue
Tone. The Cue Tone page is displayed.
2 The Sequence Number lists the tone sequences. The receiver supports up to 16
tone sequences. You can configure the state, tones, mode, and delay for each tone
sequence.
3 From the Sequence State drop-down list, choose to enable or disable the current
tone sequence. When disabled, no cue tone is output.
4 In the Sequence Tones field, set the three digit tone sequence (1 to 999).
5 Choose the tone sequence mode from the Sequence Mode drop-down list.
Choose * for start tone, # for the end tone, and */# for the start and end tones.
The end tone is signaled after waiting the time specified in Sequence Delay.
6 If the Sequence Mode was set to */# (Start/Stop), set the Sequence Delay, in
seconds, between the start and stop sequences. You can enter a value in the
range from 1 to 255. The default is 30.
7 Click Apply.
Setting up Audio and Video Information
187