Cisco D9858 Installation And Configuration Manual page 89

Menu Item Description
L-Band This is the L-Band operating frequency used by
the receiver. This value is determined by the
values set in the Freq and LO options.
RF Lock Indicate whether the tuner has locked onto the
Radio Frequency signal with the current
settings.
Modulation Sets the modulation type for the received
signal.
Rolloff Sets the rolloff factor of the incoming signal.
InputIQ Select the Input signal spectrum inversion
setting, which allows the operator to track and
select inverted and non-inverted digital
signals. This is normally used to automatically
reject or filter out unwanted signals.
NetID Select the Network ID of the uplink signal the
receiver is to receive. The transcoder's Network
ID must match the Network ID associated with
the transmitted signal.
LNB Power Set the power output of RF1 to the external
LNB.
Setup Menu
Parameters
950 to 2150 MHz.
Lock or NoLock.
DVB-S or DVB-S2.
.20, .25, .35. Use .20 or .35
when DVB-S modulation
is used, and either of the
three when DVB-S2 is
used. Use a small number
to reject or filter carriers
close to the same
frequency.
Auto, Normal, or
Opposite.
Auto - The signal is
tracked and inverted for
correct selection, as
required.
Opposite - The signal is
always inverted.
Normal - The signal is not
inverted.
1 to 65535. The default
value is 1.
Off, 13V, 18V, V-NIT, or
H-NIT.
V-NIT and H-NIT will use
vertical and horizontal
polarity until it is
automatically read from
the NIT.
Note: Power will not be
applied to the LNB when
set to Off.
67