Rear Connector Panel - Cisco D9858 Installation And Configuration Manual

Rear Connector Panel

The following diagram show the rear connector panel of the D9858 transcoder:
The following table describes the function and type of the various connectors.
Connector
RF Inputs
Reference Input
ASI Input
ASI Outputs
TS Output
Management
Cue Tone/Cue Trigger
Relay Outputs
RS-232 Data
Description
Each input accepts an LNB signal input.
RF1 provides LNB power for use when no
external LNB power source is available. RF2
to RF4 require an external LNB power
source.
For future use.
Asynchronous Serial Interface Input.
Three Asynchronous Serial Interface
Outputs.
This is for the MPEGoIP and MPE outputs.
The MPEGoIP output of the transport
stream is encapsulated in the IP packets to a
groomer for distribution. The MPE output
receives IP packets from the transport
stream.
Supports the following network protocols:
Telnet, SSHv2, HTTP, HTTPS, SNMPv2,
Syslog/DTX, SNTP, FTP (client side),
MPEGoIP output, and TFTP.
Program relay provides programmed
responses for alarms, cue trigger states for
ad-insertion equipment, or a cue tone
output for connection to ad-insertion
equipment.
RS-232 data output: 7 bits, even parity, 1
stop bit, up to 38.4 kbps. These outputs are
user-configurable via the Setup menu on
the front panel.

Rear Connector Panel

Type
F
BNC
BNC
BNC
RJ-45
RJ-45
15-pin sub-D female
9-pin sub-D female
23