Table of Contents
Advertisement
Chapter 5 Web GUI Setup and Monitoring
Setting the DPM General Settings
1
In the DPM General Settings area, you can configure MPEGoIP DPM transport
stream settings.
2
From the Remapping Mode drop-down list, choose the DPM map mode. The
following table describes each mode:
Map Mode
Svc ID
Svc ID & PID
3
From the Duplication Method drop-down list, choose the duplication method of
the DPM program, which modifies the PSI to duplicate a program and its
content. This parameter is only used if Remapping Mode is set to Svc ID & PID.
The following table describes the each duplication method:
Duplic Mode
PSI Remap
Pkt Copy
Pkt Copy is recommended for most applications.
4
Select the DPM action to use for Unreferenced Content. Unreferenced content is
the remainder of the transport that is not filtered by the program entries. Select
Drop (default) to drop all unreferenced content. Select Pass to pass all
unreferenced content to the output unchanged.
5
From the Service ID Output drop-down list, choose whether the transcoder
should always generate PSI tables for the Mapped PE even if the selected input
channel is not available, or for only valid service channels/IDs. The following
table describes each service ID:
Svc ID
Valid Ch
All Ch
216
Description
The elementary PIDs are not changed. Channels are remapped by
changing their PSI references. When this mode is selected, PE
detailed PID mapping cannot be edited.
Channels and the elementary service PIDs can be mapped.
Description
Every input PID can be mapped to one output PID. If PID
mapping conflicts exist, DPM will use the Precedence Rule to
decide which output PID to use. All PMTs using the input PID
will be updated to reference the output PID specified by the
winner.
An input PID can be mapped to multiple output PIDs. The PID
will be duplicated as many times as needed (up to a certain
hardware limitation).
Description
Only transmits the PSI tables for the mapped program if the
program exists on the input stream.
Transmits the PSI tables for the mapped program even if the
program does not exist in the input stream.
All Ch is only valid if the PAT, NIT, SDT and PMT are set to
Regenerate.
- Quick Links:
- Logging on to the Web Gui
Hide quick links:
Advertisement
Table of Contents
