Setting Up The Channel Selections - Cisco D9858 Installation And Configuration Manual

Chapter 5 Web GUI Setup and Monitoring

Setting up the Channel Selections

Note: If the unit is in a disaster recovery or NIT retune recovery mode, an error
message is displayed, informing you that any changes made to the page will
interrupt the disaster recovery or NIT retune process. The error message appears
when you load, refresh, or apply changes to the page. For more information on NIT
retune, see NIT Retune Recovery (on page 10). For more information on disaster
recovery, see Disaster Recovery (on page 7).
1 From the user interface of the D9858, choose Input > Channel Selection. The
Channel Selection page is displayed.
2 The D9858 is available in a single channel (Cisco D9858 -1) or a dual channel
configuration. For a dual channel transcoder, you can enter or select a channel
number for up to two program entries.
Note: The single channel transcoder (D9858-1) supports one Program Entry (PE1)
only.
3 Click Apply.
166