Cisco D9858 Installation And Configuration Manual page 90

Chapter 4 Front Panel Operation
Menu Item
22kHz
Tune Mode
Custom
This menu is where you set up your custom properties. Select the channel to set up
and then edit it.
Menu Item
Services List Mode
BAT
NIT
SDT
PAT
Frequency Tuning
68
Description
For dual band applications, select whether to
transmit the 22 kHz tone Local Oscillator
control signal of RF1.
Description
If using custom tune mode,
select which tables are required
for tuning.
This is not supported in the
current release.
If using custom tune mode,
select whether to use the
Network Information Table
(NIT) when creating the service
list.
If using custom tune mode,
select whether to use the Service
Description Table (SDT) when
creating the service list.
If using custom tune mode,
select whether to use the
Program Association Table
when creating the service list.
If using custom tune mode,
select whether to use the NIT to
tune to other transports, or to
force the tuning to user
configuration settings.
Parameters
On, Off, or Auto.
Auto uses the crossover
frequency to determine if
the tone is transmitted.
Parameters
Rigorous - Requires all service list tables
to be present to acquire the signal.
Degraded - Requires any service list
table to be present to acquire the signal.
No
Yes or No
Yes or No
Yes or No
NIT - The transcoder can change tuning
parameters to use all transports available
in the NIT.
User Cfg - The transcoder is forced to
use the user selected tuning parameters.