Setting Up Default Settings For The Transcoder - Cisco D9858 Installation And Configuration Manual

Parameter
EIT
TDT
RST
TOT
DIT
SIT
ECM
EMM
DRT
17 Check the Block CDT Output check box.
18 Click OK.
19 Click Apply.

Setting up Default Settings for the Transcoder

1 From the user interface of the D9858, choose Transport Stream > Transcoding >
Transcoder Setup. The Transcoder Setup page is displayed.
2 From the Action on Loss of Input drop-down list, choose the action that the
transcoder takes when there is a loss of input signal (No Output or Black
Output).
3 From the Transcoder 1 Output and Transcoder 2 Output drop down lists,
choose the transcode channel video mode. The selections are Auto, HD Output,
and SD Output.
Configuring Transport Stream Information
Description
Drop
Pass
Pass
Pass
Pass
Pass
Drop
Drop
Drop
221