Cisco D9858 Installation And Configuration Manual page 219

10 From the Action drop-down list, choose the action to perform on the current
PID. The Drop action is always performed, but the Map option is only applied if
the PE Action is Map and the Remapping Mode is Svc ID & PID in the DPM
General Settings section.
Action
Drop
Map
11 In the Stream Type field, enter a stream type to map within a PE to a specified
PID (0 to 255).
12 From the Category drop-down list, choose the service to configure. If an input
service matches this type and Instance, then the Action will be applied. This
value is only used if the Action is set to Map. The categories are: UNKN, CDT,
LSDT, DATA, TTX, MPE, DPI, VBI, SUBT, AUD, VID, PCR or INVL.
13 Enter the Instance (1 to 64) of the service specified by Category to configure. If
an input service matches this type and instance, then the Action will be applied.
14 If Action is set to Map, enter the Output PID number (0 to 8192).
15 Click Save.
16 Click OK.
To remove a PID mapping, click the radio button of the entry you want to
remove and click Delete.
Synchronizing the Inputs
1 In the DPM Program Entry Setup table, each PE output can be synchronized to
its input according to one of the four output modes. Click the radio button of the
program entry you want to synchronize and then click Resynchronize or click
Resynchronize All to synchronize the inputs to the outputs according to the
service assignments only. The Confirm Resynchronization window is displayed.
2 Click whether you want to synchronize the PE output according to the services
and then the PIDs assigned to each service, services only, PIDs only, or to
synchronize using a template.
Description
The service selected by the Category and Instance will be mapped
to the specified PID. This is only applied if the PE action is Map
and the Remapping Mode is Svc ID & PID.
The service selected by the Category and Instance will be removed
from the PMT and the output stream.
Configuring Transport Stream Information
197