Cisco D9858 Installation And Configuration Manual page 127

Menu Item Description
Act Select the action to perform on
the current PID.
The Drop action is always
performed, but the Map option
is only applied if the PE action
is Map and the Map Mode is
Svc ID & PID.
StTyp Enter the stream type to map
within a PE to a specified PID.
OTyp Select the service to configure.
If an input service matches this
type and instance specified by
In, then the Action will be
applied.
In Select the instance of the service
specified by OutType to
configure. If an input service
matches this type and instance,
then the Action will be applied.
PID If mapping this PID (Act is set
to Map), select the output PID
number.
PSI Table Settings
Note: The table settings are only available if you selected Ctl by Table in the PSI
Options menu. The default values for the PSI table settings are dependent on the
Output Mode. For a list of default values, see DPM Default Settings for Different
Output Modes (on page 361).
Setting
PAT
CAT
PMT
TSDT
NIT
Mode Options
Pass, Drop, Regen
Pass, Drop, Regen
Pass, Drop, Regen
Pass, Drop
Pass, Drop, Regen, PwRC Network Information
Parameters
Map - The service selected by the
OutType and Instance will be
mapped to the specified PID. This is
only applied if the PE action is Map
and the Map Mode is Svc ID & PID.
Drop - The service selected by the
OutType and Instance will be
removed from the PMT and the
output stream.
0 to 255
UNKN, ETV, CDT, LSDT, DATA,
TTX, MPE, DPI, VBI, SUBT, AUD,
VID, PCR or INVL
1 to 64
1 to 8190
Description
Program Association
Table
Conditional Access Table
Program Map Table
Transport Stream
Description Table
Table
Setup Menu
Default
Pass
Pass
Pass
Pass
Pass
105