Cisco D9858 Installation And Configuration Manual page 326

Chapter 6 Service and Maintenance
Alarm Message
Type
Decoder Set
Processor Start
Decoder Set
Processor Start
LEC Timeout Set
LEC Timeout Clear
FPGA status Set
FPGA status Set
304
Message Cause/Remedy
No Response Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
Synchronization Cause: Hardware
Failure issue.
Remedy: Clear
alarms, reset the
unit, and notify
Cisco Services if the
problem persists.
LEC Table Cause: Possible
Missing/timeout: LEC Server or
channels currently
Uplink issue.
unavailable
Remedy: Check
LEC Server setup
and the uplink
configuration for
the GDS PID
setup. Clear
alarm and notify
Cisco Services if
problem persists.
LEC received –
FPGA Init failed to Cause: Hardware
go high issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA Init and Cause: Hardware
Done failed to go
issue.
low
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
Description Severity
Secondary Major
processor not
responding.
Communicati Major
on with
secondary
processor
failing.
ECT Table is Major
not received in
the GDS
stream.
– Major
FPGA setup Major
failure or the
FPGA binary
identity does
not match the
FPGA
registers.
FPGA setup Major
failure or the
FPGA binary
identity does
not match the
FPGA
registers.
ID
38000
38000
38500
38500
39000
39000