Removing The Deck Open Switch Pcb - Canon 1130 Service Manual

2. Removing the Deck Open Switch
PCB
1) Disconnect the deck from the copier, and
push the latch plate [2] of the compartment
[1] to open the compartment [1].
2) Remove the three screws [3], and
disconnect the connector [4]; then, detach
the front upper cover [5].
3) Remove the two screws [6], and detach
the deck open switch PCB [7].
When mounting the front
upper cover, be sure not to
trap the harness by the deck
open switch PCB, and be
sure
connectors.
COPYRIGHT © 2002 CANON INC.
to connect all
CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 10 PAPER DECK
[2]
(rear)
Figure 10-349
[3]
Figure 10-350
Figure 10-351
[1]
[4] [5]
[7]
[6]
10-39