CHAPTER 11 INSTALLATION
2. Installing to the Copier
When installing the copy data controller
to the copier, keep the following in mind:
1. Be sure to comply with the laws and
regulations of the country.
2. Be sure that the copier has been
properly installed.
3. Be sure that the copier's power plug is
disconnected.
4. Be sure to identify the screws by type
(length, diameter) and location.
5. Be sure to prepare settings data on the
computer at the service station (if
remote control is planned).
1) Remove the four screws [2], and detach the
face plate [1] of the copier's rear cover.
11-34
COPYRIGHT © 2002 CANON INC.
[2]
[2]
CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
Figure 11-606