Canon 1130 Service Manual page 444

7) Disconnect the connector A [4], and shift
the lamp regulator unit slightly to the
front, and disconnect the connector B [5]
and connector C [6]; then, detach the lamp
regulator PCB.
8) Remove the three screws [7], and detach
the duct [8] of the primary charging
assembly fan.
9) Remove the three screws, and disconnect
the connector; then, detach the primary
charging assembly fan.
10) Remove the screw [9] and the two hex-
hole stop screws [10]; then, detach the
gear [11] from the drum shaft.
COPYRIGHT © 2002 CANON INC.
CHAPTER 9 EXTERNALS / AUXILIARY MECHANISMS
CANON CLC1100/1130/1150/1160/1180 REV.1 JAN. 2000 PRINTED IN JAPAN (IMPRIME AU JAPON)
[5]
Figure 9-727
[7]
[8]
Figure 9-728
[9]
Figure 9-729
[6]
[4]
[7]
[7]
[10]
[11]
9-29