Canon 1130 Service Manual page 596

When Replacing the Transfer
12
Drum Assembly
If you have replaced the transfer drum,
perform the following in service mode
(ADJUST>FEED-ADJ; p. 13-7):
1. Adjusting the attraction position (ATT-T-
A, ATT-T-B)
2. Adjusting the image leading edge margin
(RG-XA, RG-XB, RG-Y)
3. Transfer delay (TR-DLY-A, TR-DLY-B)
4. Adjusting the image trailing edge margin
(TR-END-A, TR-END-B)
Position of the Paper
13
Deflecting Plate Solenoid
(SL10; delivery assembly)
Loosen the adjusting screw [4] to make
adjustments while the paper deflecting plate
[2] is butting against the delivery upper guide
[3] when the solenoid [1] is on (viewing the
delivery assembly from the side at the rear).
Applying Lubricant to the
14
Transfer drum Cleaner
1) Use a specific lubricant (e.g., FY9-6006).
2) Put a drop of lubricant (one drop each) at
points indicated (A).
3) Turn the gear several times by hand so
that the lubricant spreads inside the
bushing.
4) Put another drop (one each) once again,
and repeat step 3.
5) When all amounts of lubricant have
spread to the inside of the bushing, wipe
the excess lubricant with lint-free paper
(indicated by dashed lines).
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 JAN. 2000 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 13 TROUBLESHOOTING
[2] [3]
Figure 13-247
Figure 13-247a
[1] [4]
13-27