Removing The Editor Mirror - Canon 1130 Service Manual

When mounting the editor
control PCB, be sure to
match the ON/OFF nota-
tions of the switches [1]
and [2] on the PCB by re-
ferring to the switch set-
tings indicated on the flat
cable.

2. Removing the Editor Mirror

1) Remove the six face plates for screws.
2) Remove the two screws (M8x8), six
screws (M8x10), and six screws (M8x28),
a total of 14 screws; then, detach the
copyboard cover.
3) Remove the two screws, and detach the
controller PCB cover.
4) Remove the flat cable [1], and five screws
[2]; then, remove the controller PCB
support plate [3].
5) Remove the mirror plate [4].
COPYRIGHT © 2002 CANON INC.
CHAPTER 9 EXTERNALS / AUXILIARY MECHANISMS
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
[2]
Figure 9-718
[1]
[3]
[2]
Figure 9-719
[1]
[4]
[2]
9-25