Canon 1130 Service Manual page 243

CHAPTER 6 IMAGE FORMATION SYSTEM
5) Remove the screw [7], and disconnect the
two connectors [8]; then, detach the black
hopper.
In the case of the magenta hopper, remove
the three screws [9]; then, detach the
support plate [10] and the drive belt [11]
in advance.
6) Remove the E-ring [12], gear 1 [13],
bushing [14], E-ring [15], E-ring [16],
and bushing [17], and disconnect the
connector [18] of the hopper driver
assembly; then, remove the clutch.
6-76
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 JAN. 2000 PRINTED IN JAPAN (IMPRIME AU JAPON)
[8]
[7] [9]
[10]
Figure 6-662
[12] [13] [14] [15]
[17] [16] [18]
Figure 6-663
[11] [9]