Canon 1130 Service Manual page 164

E071
ITOP sensor error
Detail
code
F000
0001
0002
0003
0004
0005
0006
0007
0008
1001
1002
1003
1004
1005
1006
1007
1008
1101
COPYRIGHT © 2002 CANON INC.
The signal from the sensor is not detected for 10 sec after the start of
transfer drum engagement.
The sequence of signals (falling edge) from the signal plate detected by
the side B sensor is not correct.
The sequence of signals (rising edge) from the signal plate detected by
the side B sensor is wrong.
The sequence of signals of the SP-C (rising edge) detected by the C
sensor is wrong.
The sequence of signals of the SP-C (falling edge) detected by the C
sensor is wrong.
The sequence of signals (rising edge) from the signal plate detected by
the side A sensor is wrong.
The sequence of signals (falling edge) of the signal plate detected by the
side A sensor is wrong.
The sequence of signals of the SP-D (rising edge) detected by the C
sensor is wrong.
The sequence of signals of the SP-D (falling edge) detected by the C
sensor is wrong.
The signal (falling edge) of the side B sensor is not generated after the
signal of the SP-D (falling edge) has been generated.
The signal (rising edge) of the side B sensor is not generated after the
signal of the SP-C (rising edge) has been generated.
The signal of the SP-C (rising edge) is not generated after the signal of
the side B sensor (falling edge) has been generated.
The signal of the SP-C (falling edge) is not generated after the signal of
the side B sensor (rising edge) has been generated.
The signal of the side A sensor (rising edge) is not generated after the
signal of the SP-C (falling edge) has been generated.
The signal of the side A sensor (falling edge) is not generated after the
signal of the SP-D (rising edge) has been generated.
The signal of the SP-D (rising edge) is not generated after the signal of
the side A sensor (rising edge) has been generated.
The signal of the SP-D is not generated (rising edge) after the signal of
the side A sensor (falling edge) has been generated.
The signal of the side B sensor (falling edge) is generated 10 ms earlier
than normal after the signal of the SP-D (falling edge) has been
generated.
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 IMAGE FORMATION SYSTEM
Error description
6-5