Siemens SIDOOR ATD4 W Series System Manual page 197

Parameter ID Adjustment range
p2205 0..500
Specific door range of motion
p3686 See p3682 corresponding motor type in
section Profiles and adjustment ranges
(Page 329)
p3687 See p3683 corresponding motor type in
section Profiles and adjustment ranges
(Page 329)
p3688 See p3664 corresponding motor type in
section Profiles and adjustment ranges
(Page 329)
p3689 See p3668 corresponding motor type in
section Profiles and adjustment ranges
(Page 329)
Obstruction and reversing parameters
Table 5-34 Obstruction and reversing parameters (general)
Parameter ID Adjustment range
General
p3850 0..255
1)
Bit x = 1 ≙ function acti‐
vated
Bit x = 0 ≙ function de‐
activated
Expert parameters, see section Expert configuration (Page 90).
1)
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA
5.9 Operation and configuration of the control unit
Factory set‐ Unit
ting
0 cm
N
N
mm/s
mm/s
Factory set‐ Unit
ting
255 —
Description
Initial operation:
Because the absolute position is not known in initial
operation, the width in Close direction is specified here
starting from the current position.
0 ≙ area deactivated.
Force limit in specific door range in OPEN direction
Force limit in specific door range in CLOSE direction
Speed limit in specific door range in OPEN direction
Speed limit in specific door range in CLOSE direction
Description
Function control
Bit 0 ≙ stop obstruction detection in the closing direc‐
tion
Bit 1 ≙ force obstruction detection in the closing direc‐
tion
Bit 2 ≙ obstruction counter in the closing direction
Bit 3 ≙ slow obstruction approach in the closing direc‐
tion
Bit 4 ≙ stop obstruction detection in the opening di‐
rection
Bit 5 ≙ force obstruction detection in the opening di‐
rection
Bit 6 ≙ obstruction counter in the opening direction
Bit 7 ≙ slow obstruction approach in the opening di‐
rection
Controllers
195