Mitsubishi Electric MELSEC Q Series User Manual page 34

2 SYSTEM CONFIGURATION
(b) Installing to a MELSECNET/H remote I/O station
Usable network
module
QJ72LP25-25
QJ72LP25G
QJ72BR15
(Note-1): Limited within the range of I/O points for the network module.
(Note-2): Can be installed to any I/O slot of a base unit.
REMARK
The basic model QCPU and C Controller module cannot configure the
MELSECNET/H remote I/O network system.
(2) Support of the Multiple CPU system
When using the QD74MH in a Multiple CPU system, refer to the QCPU User's
Manual (Multiple CPU system).
(3) Supported software packages
GX Developer is required for use of the QD74MH.
The compatibility between the systems using the QD74MH and the software
packages is shown below.
Q00JCPU/Q00CPU/Q01CPU
Q02CPU/Q02HCPU/Q06HCPU/
Q12HCPU/Q25HCPU
Q02PHCPU/Q06PHCPU
Q12PHCPU/Q25PHCPU
Q02UCPU/Q03UDCPU/Q04UDHCPU/
Q06UDHCPU
Q13UDHCPU/Q26UDHCPU
Q03UDECPU/Q04UDEHCPU/Q06UDEHCPU/
Q13UDEHCPU/Q26UDEHCPU
For use on MELSECNET/H remote I/O station
Number of installable
(Note-1)
modules
Up to 64
Single PLC system
Multiple PLC system
Single PLC system
Multiple PLC system
Single PLC system
Multiple PLC system
Single PLC system
Multiple PLC system
Single PLC system
Multiple PLC system
Single PLC system
Multiple PLC system
Single PLC system
Multiple PLC system
2 - 3
Usable base unit
Main base unit of Extension base unit of
remote I/O station remote I/O station
: Applicable,
Software version
GX Developer
Version 7 or later
Version 8 or later
Version 4 or later
Version 6 or later
Version 8.68W or later
Version 7.10L or later
Version 8.48A or later
Version 8.62Q or later
Version 8.68W or later
Version 6 or later
MELSEC-Q
(Note-2)
: Not applicable