9 MANUAL CONTROL
9.2.2 Precautions for control
9.2.3 Data used for control
Symbol
Parameter
Pr.84
If the following setting value is set that it decelerates at once after it reaches the
specified JOG speed by acceleration and is set, it does not reach the specified JOG
speed, and the constant speed section is caused.
• "
JOG operation acceleration time"
Pr.82
• "
JOG operation deceleration time"
Pr.83
• "
JOG speed"
Pr.80
• "
Incremental feedrate"
Pr.84
If it does not reach the specified JOG speed because the setting value of "positioning
address/movement amount" is small, it becomes operation similar to the above.
Command speed
Da.4
Actual speed
If the setting value of "
speed section might become long.
The parameters and control data used for incremental feed operation are shown
below.
Refer to Section 6.3 to 6.8 for the buffer memory address and details.
Item
Incremental feedrate
JOG operation acceleration time" is short, the constant
Pr.82
Set the feedrate for incremental feed.
9 - 6
MELSEC-Q
Details