GE AF-650 GP Programming Manual page 119

Parameter Descriptions
EN-32 Net Control
Option: Function:
Read-only. Displays the control source in Instance
21/71.
[0] Off Control via the network is not active.
*
3 3
[1] On Control via the network is active
EN-33 CIP Revision
Option:
[0] Major version (00 - 99)
[1] Minor version (00-99)
EN-34 CIP Product Code
Range:
201 [0 - 65535]
*
EN-35 EDS Parameter
Range:
0 [0 - 0]
*
EN-37 COS Inhibit Timer
Range:
[0–65.535
ms]
EN-38 COS Filters
Range:
[[0-9] Filter 0–9
(0000-FFFFhex)]
EN-40 Status Parameter
Range:
NOTICE
0 [0 - 0]
*
This parameter is for Modbus TCP only
EN-41 Slave Message Count
Range:
NOTICE
0 [0 - 0]
*
This parameter is for Modbus TCP only
EN-42 Slave Exception Message Count
Range:
NOTICE
0 [0 - 0]
*
This parameter is for Modbus TCP only
118
Function:
Read-only. Displays the CIP-version of
the option software.
Function:
Read-only. Shows the CIP product code.
Function:
Function:
Read-only change-of-state inhibit timer. If the
option is configured for COS operation, this inhibit
timer can be configured in the forward open
telegram to prevent that continuously changing
PCD data generates extensive network traffic. The
inhibit time is in ms, 0=disabled.
Function:
Change-of-state PCD filters. Sets up a filter
mask for each word of process data when
operating in COS-mode. Single bits in the
PCDs can be filtered in/out.
Function:
Function:
Function:
EN-80 FTP Server
Option:
[0] Disabled
*
[1] Enabled
EN-81 HTTP Server
Option:
[0] Disabled
*
[1] Enabled
EN-82 SMTP Service
Option:
[0] Disabled
*
[1] Enabled
EN-89 Transparent Socket Channel Port
Range:
0 [0–9999] Configures the TCP port-number for the
*
EN-90 Cable Diagnostic
Option:
[0] Disabled
*
[1] Enabled
EN-91 Auto Cross-Over
Option:
[0] Disable Disables the auto cross-over function.
[1] Enable Enables the auto cross-over function.
*
02/2016 All rights reserved.
Function:
Disables the built-in FTP server.
Enables the built-in FTP server.
Function:
Enables the built-in HTTP (web) server.
Function:
Enables the SMTP (e-mail) service on the option.
Function:
transparent socket channel. This enables Drive-
messages to be sent transparently on Ethernet via
TCP. Default value is 4000, 0 means disabled.
Function:
NOTICE
The cable diagnostics function is only
issued on ports where there is no link (see
parameter EN-10 Link Status, Link Status)
Enables/disables advanced cable diagnosis
function. If enabled, the distance to cable errors
can be read out in parameter EN-93 Cable Error
Length. The parameter resumes to the default
setting of disable after the diagnostics have
finished.
Function:
NOTICE
Disabling of the auto cross-over function
requires crossed Ethernet cables for daisy-
chaining the options.
DET-618D